NANO-AGR-SMA

NANO AGR RTK Receiver

NANO AGR RTK Receiver is a multi-constellation, multi-frequency RTK receiver.
It is based on Allystar's new generation dual-core GNSS SoC and supports up to 10Hz data output.
NANO AGR RTK Receiver supports conventional RTK base and rover functions.
It supports a maximum of 128 hardware channels and can receive almost all visible satellites.

Feature

• Output rate 5Hz default, max up to 10Hz
• Support Multi-bands Multi-constellations
• Support RTCM output and input
• Support NMEA output
• Support setup base staion automaticlly
• Support dual-UART interface

Specifications

GNSS

• GNSS Constellation
  • GPS/QZSS L1, L5
  • GALILEO E1, E5a
  • GLONASS G1
  • BDS B1I B2a
• Frequencies: L1+L5
• Channels: 128 hardware channels
• Protocol
  • NMEA output, GGA/GSA/GSV/VTG/ZDA/GLL/RMC/GST/TXT
  • RTCM v3 input and output (support MSM7 output, MSM4/MSM5/MSM7 input)
• Output rate: 1/5/10 Hz
  • 5Hz default (Dual-band, GPS/GALILEO/BDS/QZSS)
  • 10Hz (Dual-band, GPS/GALILEO/BDS/QZSS, GGA/RMC/VTG 10Hz other messages 1Hz)

Accuracy

• Single Positioning
  • 1.5m CEP
• RTK Positioning
  • H: 1cm + 1PPM
  • V: 3cm + 1PPM

Interface

• UART: 2 UART, default 230400bps
• RF: SMA-K connector
• 2.54mm Pin Header, 20 pins

Electronic

• Input Vcc: 3.3V (Typical)
• TTL level: 1.8~3.6V

Environment

• Operational temp.: -20~85℃

Pin definition

GNSS Antenna recommendation

There is a built-in LNA and SAW in the module.
It is recommended to use an active antenna with gain less than 30 dB and the noise figure less than 1.5 dB.

Test utilities

Top Left: Position information Top Right: Data monitor
Bottom Left: Signal Bottom Right: Config command

Download Satrack latest version.

Quick guide for Satrack