Difference between revisions of "NANO-EVK"
Jump to navigation
Jump to search
| Line 21: | Line 21: | ||
* How to use it | * How to use it | ||
[[File:FT232RL_windows_driver.zip|EVK USB Serial driver for Windows]] | |||
1. To start using the Evaluation kit, please make the following prepared: | 1. To start using the Evaluation kit, please make the following prepared: | ||
*EVK | *EVK | ||
Revision as of 16:09, 7 September 2023
EVK-PRO
EVK is a simple, friendly demo kit to evaluate the ALLYSTAR GNSS modules. It integrates a USB interface to power the board and communicates with PC.
It supports TAU1302/TAU1312/TAU1308/TAU1202/GEM1111.
- 5 Pins Header
support input and output 5V power supply, and support output data from this header
- 1.25mm Pitch connector
support output data from this connector
- Button and LED
1. Reset button(PRRSTX), Press the reset button to generate a hardware reset to the module. 2. Boot button(PRTRG), The boot button is used to set the module to enter BootROM command mode. In this mode the module executes only the minimal functionality, such as updating new firmware. 3. Follow these steps to enter BootROM command mode: *Press and hold the BOOT button first, and then press RESET button. After that, release the RESET first, and then release the BOOT button. 4. The power LED indicates the power status. When the module is powered on, the LED is on.
- How to use it
File:FT232RL windows driver.zip
1. To start using the Evaluation kit, please make the following prepared: *EVK *GNSS Antenna *USB cable 2. Install the latest version of Satrack for Windows to the PC.