Difference between revisions of "Faq-how-to-config-output-rate"

From DATAGNSS Wiki
Jump to navigation Jump to search
 
(6 intermediate revisions by the same user not shown)
Line 2: Line 2:


1. open the AS message window
1. open the AS message window
[[File:Satrack-as-message-view.png|300px|frameless|satrack]]
 
[[File:Satrack-as-message-view.png|700px|frameless|satrack]]


2. tap to "CFG-PWRCTL2 "
2. tap to "CFG-PWRCTL2 "
[[File:output-rate-1hz.png|400px|frameless]]
[[File:5hz-output-rate.png|400px|frameless]]
3. tap menu "tools" - "set NMEA message" or "set RTCM message"
[[File:nmea-output-rate.png|400px|frameless]]
[[File:rtcm-output-rate.png|400px|frameless]]
The menu here is primarily for setting the sampling rate. For instance, if the setting in cfg-pwrctl2 is 200ms, that equates to 5Hz.
If you set it to 1 here, the output rate would be 5Hz. If you set it to 5, the output rate would then become 1Hz.
However, it is generally not recommended to have a sampling rate that is a multiple other than 1. If you desire a 1Hz rate,
it is more advisable to set it to 1Hz directly in cfg-pwrctl2.
=== Reference ===
You can also refer to this FAQ here.
[https://docs.datagnss.com/rtk-board/#8enabledisable-specific-message-output How-to-enable-specific-message-output]

Latest revision as of 12:12, 4 May 2024

How to config output rate

1. open the AS message window

satrack

2. tap to "CFG-PWRCTL2 "

Output-rate-1hz.png

5hz-output-rate.png

3. tap menu "tools" - "set NMEA message" or "set RTCM message"

Nmea-output-rate.png

Rtcm-output-rate.png

The menu here is primarily for setting the sampling rate. For instance, if the setting in cfg-pwrctl2 is 200ms, that equates to 5Hz.

If you set it to 1 here, the output rate would be 5Hz. If you set it to 5, the output rate would then become 1Hz.

However, it is generally not recommended to have a sampling rate that is a multiple other than 1. If you desire a 1Hz rate,

it is more advisable to set it to 1Hz directly in cfg-pwrctl2.

Reference

You can also refer to this FAQ here.

How-to-enable-specific-message-output